Primarily designed for the MP7A1 and also fits M11 and UZI series. Made of INVISTA CORDURA, uses UTX clips. This holster can holds 1 magazine and Mp7A1.(MP7A1 is not included). This MP7 holster is very high finishing laylax replica in the airsoft market now.
Capable of holstering your beloved MP7A1 without defacing its bodywork, the MP7 dropleg holster is also capable of holding an additional mag, just in case your first mag runs out. Fully adjustable in size for either a tight fit for constant movement, or a loose fit for quick draw scenarios, the Pantac MP7 Dropleg holster is a great investment if you do indeed own that lovely piece of weaponry!
Made of light weight abrasion and water resistant 1000D Invista Cordura fabrics with YKK zippers, ITW Nexus & UTX buckles with Mil-Spec. Sewing Seams and UTX top quality brass snap buttons adopted. Mil-Spec. Velcro is good for over 20,000 uses.
Mil-Spec. 420 denier Nylon liner improving durability and water resistance.
All Pantac gear is made to comply with Heavy Duty Military Specifications.
- Fit Marui / KSC / KWA MP7 series or UZI, M10 .
- QD buckle about you detach holster from leg belt in a second
- Adjustable Length.
- Suitable for most BDU / Duty / MOLLE Belt.
- Built in magazine pouch
Special Feature of Pantac products :
- Heavy-duty, abrasion and water resistant 1000 denier INVISTA Cordura Ballistic Nylon Fabric exterior construction.
- # Crye Precisoin heaviest MULTICAM 500/1000 Denier CORDURA fabric used for all Pantac Multicam Camoflage products.
#Multicam Fabric SPES:
Finished Width - 60 inches cuttable
Finished Weight - 9.8 oz/yd approximately
Fiber Content - 100% nylon
Construction - 35/30 (warp/fill)
Breaking Strength - 593/580 (warp/fill) (lbs, minimum
- Highest quality and best selection of YKK zippers for Pantac Products
- Military specification nylon webbing
- ITW Nexus and UTX buckles are adopted to comply military specification
- Heavy duty mil. spec. sewing seam, 6 plied nylon yarn
Lunes, 29 Julio 2019